Heat Transfer Printer Operation Manual-Wuxi huiruida Intelligent Equipment Co., Ltd.

HUIRUIDA — Focus on the Smart Device Industry

E-mail: info@wxhrdgroup.com

/ sales@wxhrdgroup.com

Get Quote

Language

Home

Heat Transfer Printer Operation Manual

Dec 02,2025

Plug the power cord into an outlet and turn on the power switch. The power indicator light will illuminate immediately.

1. Plug the power cord into an outlet and turn on the power switch. The power indicator light will illuminate immediately.
2. Adjust the thermostat to the desired temperature. Once the set temperature is reached, the indicator light on the thermostat will turn off, indicating it is ready for operation.
3. Set the timer to the required duration.
4. Lay the garment flat on the lower ironing plate, place the iron-on transfer paper on top (note the correct orientation), and press the handle down firmly until it stops. Caution: Do not apply force exceeding 30 kg, as this may deform the handle.
5. When the timer reaches the preset ironing time, the buzzer will sound. Immediately lift the handle back to its original position.
Precautions:
1. Pressure: If pressure is insufficient or excessive, adjust the pressure knob at the rear of the machine. Turning clockwise increases pressure; counterclockwise decreases it.
2. Time: If the buzzer fails to sound or sounds continuously when the pressing time ends, adjust the timer to the appropriate setting.
3. Temperature: When the set temperature is reached, the thermostat needle will point to “180℃” (approximately 5 minutes). If the thermometer rises upon startup but the heating plate does not heat up, check the circuit.
4. If the handle automatically returns upward when released after being pressed down fully, adjust the knob downward.
5. If lifting the handle feels difficult after hot stamping, adjust the knob downward.

TAG:

UV Coating Roll Coating Knowledge Explained

None!

Related News